Zoeken
Cataloghi
- Alpa
- DORMER
- GERARDI
- IMET
- KEMMLER
- Link
- PRAMET
- Vardex
- Voelkel
- Walter
- SANDVIK_COROMANT
Arbors for screw-in cutters
Toon als
Sorteren op
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.10.3
Meer details
|
Van €99.75
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.10.5
Meer details
|
Van €120.00
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.10.0
Meer details
|
Van €66.00
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.10
Meer details
|
Van €69.75
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.10.1
Meer details
|
Van €75.00
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.10.2
Meer details
|
Van €87.00
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.12.3
Meer details
|
Van €99.75
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.12.5
Meer details
|
Van €120.00
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.12.0
Meer details
|
Van €66.00
|
|
Application: For mounting screw-in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle...
403.06.12
Meer details
|
Van €69.75
|